Can Present Sensor with Quick Connect electrical Nominal width: 5

Nominal width: 5

This four pin connecting cable is 5m (16

This M8 3-wire connector cable is used with most Wild Goose Filling systems and has one molded female end and three wires on the other

This flow control fitting is used to control the speed of the cylinder's extend and retract motions

The can present sensor is used on all EVO and WG8/10 systems

Can Present Sensor with Quick Connect electrical Nominal width: 5The can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.